Pengaruh Limbah Keramik dan Abu Terbang Terhadap Kuat Tekan dan Daya Serap Air Bata Beton
Abstract
The growth of development sector in Indonesia lead a high demand for cement and sand. The research was conducted from February to July 2018 with objectives of analyzing and knowing the influence of mixture of ceramic waste and fly ash on compressive strength and water absorption of paving block. The research was started from preparation of tools and materials, manufactured of specimens and also tested the compressive strength and absorption of paving block. Quality standardwere based on SNI 03-0691-1996. Based on the analysis result, the highest compressive strength of 26.56 Mpa was obtained from paving block with 9% fly ash and 6% ceramic waste and was classified as class B. The highest water absorption of 18.29% was paving block with 15% mixtured of ceramic wastes and the lowest water absorption of 9.65% was normal paving block. Brick concrete with 6% mixture of ceramic waste and 9% fly ash had several advantages, i.e. cheaper cost, had a higher compressive strength and higher water absorption compared to normal paving block, more environmental friendly, had lighter weight and ease of installation.
Key words: ceramic wastes, compressive strength, fly ash, paving block, water absorption
Downloads
References
Akmalia R, Olivia M, Kamaldi A. 2016. Kuat tekan dan sorptivity beton dengan kulit kerang (Anadara granosa). Jom FTEKNIK. 3 (2) : 1-14.
Alfiansyah A. 2017. Pengaruh kapur terhadap kuat tekan dan permeabilitas paving block geopolymer berbahan dasar abu terbang dan lumpur lapindo. Rekayasa Teknik Sipil. 1 (1) : 412-423.
[ASTM] American Standard Testing and Material. 2003. Standard Spesification for Fly Ash and Raw or Calcinated Natural Pozzolan for Use as a Mineral Admixture in Portland Cement Concrete ASTM-C618-03-2003. Amerika Serikat (US) : American Standard Testing and Material.
[BSN] Badan Standardisasi Nasional. 1996. Bata Beton (Paving Block) SNI 03-0691-1996. Jakarta (ID) : Badan Standardisasi Nasional.
[BSN] Badan Standardisasi Nasional. 2004. Semen Portland SNI 15-2049-2004. Jakarta (ID) : Badan Standardisasi Nasional.
[Dep PU] Departemen Pekerjaan Umum. 1990 a. Metode Pengujian Tentang Analisis Saringan Agregat Halus dan Kasar SNI 03-1968-1990. Jakarta (ID) : Yayasan LPMB.
[Dep PU] Departemen Pekerjaan Umum. 1990 b. Metode Pengujian Kadar Agregat SNI 03-1971-1990. Jakarta (ID) : Yayasan LPMB.
[Dep PU] Departemen Pekerjaan Umum. 1990 c. Tata Cara Pembuatan Rencana Campuran Beton Normal SK SNI T-15-1990-03. Bandung (ID) : Yayasan LPMB.
[Dep PU] Departemen Pekerjaan Umum. 1991. Spesifikasi Abu Terbang Sebagai Bahan Tambahan Untuk Campuran Beton SNI 03-2460-1991. Jakarta (ID) : Yayasan LPMB.
Fitriana R, Anjarwati S, Azizi A. 2016. Pengaruh penggantian sebagian semen dengan fly ash dan kapur terhadap kuat tekan paving block. Prosiding Simposium Nasional Teknologi Terapan (SNTT) 4 2016. Purwekerto (ID) : Universitas Muhammadiyah Purwokerto. 612-616.
Mulyati, Maliar S. 2015. Pengaruh penggunaan fly ash sebagai pengganti agregat terhadap kuat tekan paving block. Jurnal Momentum. 17 (1) : 42-49.
Mulyono T. 2004. Teknologi Beton. Yogyakarta (ID) : Andi.
Nurzal, Taufik. 2016. Pengaruh lama pengeringan paving block dengan penambahan 5% fly ash terhadap kuat tekan (binder air mineral). Jurnal Teknik Mesin Institut Teknologi Padang. 6 (1) : 43-49.
[Puslitbang TMB] Pusat Penelitian dan Pengembangan Teknologi Mineral dan Batubara. 2015. Statistik Keramik. http://www.tekmira.esdm.go.id/data/komoditiStatistik.asp ?xdir=Keramik&commId=23&comm=Keramik[di akses tanggal 21 Agustus2017].
Respati SMB, Soenoko R, Irawan YS, Suprapto W. 2015. Pengaruh persentase zeolit alam terhadap shrinkage matrik alumina zeolit alam keramik komposit. Prosiding SNST ke-5 Tahun 2014. Semarang (ID) : Universitas Wahid Hasyim. 90-94.
Subekti S. 2009. Limbah padat keramik sebagai bahan campuran batako ditinjau terhadap kuat tekan. Prosiding Seminar Nasional Aplikasi Teknologi Prasarana Wilayah 2009. Surabaya (ID) : Institut Teknologi Sepuluh Nopember. 529-534.
Sukirman S. 2003. Beton Aspal Campuran Panas. Jakarta (ID) : Yayasan Obor Indonesia
Authors who publish with Jurnal Teknik Sipil dan Lingkungan, JSIL agree to the following terms:
a. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
b. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
c. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
